JarCasting
Introduction
The basic load step executes the same type of operation for each item supplied by the input. It's easy to execute several types of operations by executing a sequence of the load steps:
However, sometimes it's necessary to execute the different types of operations on the items asynchronously (e.g. each item traverses through the "pipeline" of load operations):
Additional useful possibility is to sustain some fixed delay between the operations in the pipeline:
Limitations
-
The count of the items which may be temporarily stored in the exchange buffer is limited in order to avoid the memory exhaustion.
-
In the distributed mode the system time on the hosts involved in the test should be synchronized precisely if the delay between operations is used.
-
There are the configuration parameters which are shared by the pipeline step's load contexts and may not be set independently:
load-step-idload-step-limit-timeThe values for these parameters are taken from the 1st configuration element of the pipeline load step.
-
The
item-output-fileconfiguration parameter value is taken from the last configuration element of the pipeline load step.
Requirements
-
Execute the sequence of the configured load operations on the items asynchronously.
-
Drop the corresponding item from the pipeline if the load operation failed. E.g. if a pipeline consists of two operations (Create, Read) the items which are not created successfully don't pass for the subsequent reading.
-
Support the configurable minimum delay between the operations on the same item in the operations pipeline.
Design
The pipeline step is implemented as a sequence of the separate load contexts interconnected with the volatile memory FIFO buffer. This buffer acts as a load operations result output for the previous load context in the sequence and as an items input for the next load context. To support the configurable transfer delay (Req.3) the buffer contains the load operations results which contain the information about the corresponding load operation finish time.
The following rules work while the next load context requests the buffer for the new items:
- Retain every load operation result if its finish time is later than the current time minus the configured delay.
- If the load operation result is not retained by rule (1) it is converted to the corresponding item and yielded to the load context requested the next batch of items.
Configuration
item-output-delay
The minimum delay between the subsequent operations for each item. 0 (default value) means no delay. Accepts a time value (0, 1, "2s", "3m", "4h").
item-output-queue-limit
The count limit for the items which may be temporarily stored in the exchange buffer is limited in order to avoid the memory exhaustion. Default value is 1,000,000.
Reporting
TODO
